Axminster HBS350N Instrucciones de operaciones descargar pdf (Pagina 9)

Main Assembly

Hex bolts and washer (H), see ﬁg 07. Locate the three

M8 square head bolts (F), three M8 nuts/washer (G)

and the fence guide rail (2). Introduce the square

head bolts into the pre-drilled holes to the front of

the table (1) and lightly screw on a washer and nut,

see ﬁg 08. (NOTE: DO NOT TIGHTEN AT THIS POINT)

Fig 07

Fig 08

Step 3 Locate the fence guide rail (2), remove the

capping plate from the right side of the fence guide

rail by undoing the two Phillips screws and place

safely aside. Slot the square headed bolts (F) into the

guide rails “T” slot and slide on, see ﬁg 09. Secure the

Fig 09

Fig 10

rail in place by tightening the three nuts beneath

the table, see ﬁg 10. Replace the capping plate you

removed earlier, see ﬁg 11.

Fig 11

Step 4 Locate the guide fence assembly (4), ﬁt the

fence over the back rail ﬁrst then lowering the front

clamp over the fence rail (2), see ﬁg 12. Push down

the locking lever and check the fence clamps up

correctly, see ﬁg 13.

Fig 12

Continues Over...

Guide rail “T” slot

Capping plate

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Sin comentarios

Axminster HBS350N Instrucciones de operaciones Pagina 9