Axminster HBS350N Instrucciones de operaciones descargar pdf (Pagina 24)

Changing the Blade Speed

DISCONNECT THE SAW FROM

THE MAINS SUPPLY!

The bandsaw drive pulley has two speed

positions, see ﬁg 52. To change the speed from

600 to 720m/minute, follow the instructions

below.

Open the upper and lower doors, see ﬁg 48. Release

the tension on the drive belt by turning the Idler

Fig 49-50

Fig 48

Idler tensioning wheel

wheel adjusting knob anti-clockwise, thus moving the

idler wheel back

, see ﬁgs 49-50. With the drive belt

tension removed, very carefully reposition the drive

belt, see ﬁg 51. NOTE: Make sure the belt is seated

correctly in one of the drive pulley grooves. With

the belt repositioned, turn the Idler wheel adjusting

knob clockwise to re-tension the belt, enough to

prevent the belt from slipping when in operation,

but not tight to cause the belt to get hot.

WARNING! BE VERY CAREFUL

WHEN MOVING THE BELT NOT

TO TRAP YOUR FINGERS!

Fig 51

Fig 52

The picture above shows the two drive pulley

positions with the speeds available.

600m/min

720m/min

Drive pulley groove

NOTE: MAKE SUE THE DRIVE BELT IS

NOT TENSIONED TO TIGHTLY WHICH

WILL CAUSE THE BELT TO GET HOT.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Sin comentarios

Axminster HBS350N Instrucciones de operaciones Pagina 24