Axminster T-2000CK Manual de instrucciones descargar pdf (Pagina 13)

Assembly Instructions

Step 20 Locate the manometer and hose (16), remove the

ﬁxings from the lower leg square tube (2), offer up the two

pre-drilled holes in the manometer (16) with the holes in

the leg (2), replace the ﬁxing and tighten. (see ﬁg 38)

NOTE: MAKE SURE THE MANOMETER (16) IS

MOUNTED TO THE LEFT SIDE OF THE LEG!

Fig 38

Step 21 Place a small Jubilee (j) over one end of the

hose and insert it over the small outlet manifold on the

extraction funnel (11) and nip up tight, see ﬁg 39.

Fig 39

WARNING! DONT OVERTIGHTEN THE JUBILEE

CLIP TO PREVENT THE HOSE FROM SPLITTING!

Hose

Step 22 Connect the other end of the hose to the inlet

manifold to the rear of the manometer (16), see ﬁg 40.

Fig 40

Step 23 Locate the inlet moulding (13) and the 12unc

screw (i). Insert the moulding over the outlet manifold

on the extraction funnel (11), line up the pre-drilled

holes and secure using the 12unc screw and Phillips

screw driver, see ﬁg 41.

Fig 41

Step 24 Finally go round and make sure all ﬁxings are

tight and secure.

CONNECT THE POWER SUPPLY TO THE MAINS

AND SWITCH ON!

DISCONNECT THE POWER SUPPLY FROM THE

MAINS!

Wait until it’s up to full speed and check for signs of

vibration, if all is well.. switch off and wait until the

extractor has come to a compleate stop!

If the extractor fails to start up or any other strang

noises apart from vibraction sounds, contact the

“Technical Sales” for support.

Phone: 03332 406406

Email: technical@axminster.co.uk

Testing the extractor

WARNING!! MAKE SURE CHILDREN ARE KEPT

AWAY FROM THE CYCLONE EXTRACTOR WHILE

IN OPERATION

NOTE: ALWAYS TURN ON/OFF THE EXTRACTOR

BY THE NVR CONTROL SWITCH NOT THE MAINS

SWITCH!

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Comentarios a estos manuales

Sin comentarios

Axminster T-2000CK Manual de instrucciones Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Depurador Axminster T-2000CK