Axminster TS-200 Instrucciones de operaciones descargar pdf (Pagina 18)

Assembly

Fig 58

Fig 59-60

Pre-drilled holes

2. Place an M6x16mm Hex bolt (W3) in each of the

four clearance holes on both support arms (V) and

loosely screw on an M6 nut and washer, see ﬁg 61.

3. Locate the four M6x30mm Hex Bolts (W1) and

lightly screw each bolt into the threaded holes to

the underside of the carriage arm (X), see ﬁg 62.

NOTE: Only screw on the bolts just enough so they

are just below the surface of the threaded nut, see

ﬁg 11.

4. Line up the Hex bolts (W3) with the ‘T’ slots in the

carriage arm (X) and slide on the carriage arm, see

ﬁg 63.

5. Locate the sliding carriage table (Y) and slide it

onto the carriage arm (X), see ﬁg 64.

Fig 61

Fig 62

Fig 63

Threaded nuts

‘T’ Slot

MAKE SURE THE WHEELS ON

THE CARRIAGE TABLE ENGAGE

CORRECTLY ONTO THE CARRIAGE

ARM RAILS, SEE FIG 65.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Sin comentarios

Axminster TS-200 Instrucciones de operaciones Pagina 18