Axminster Router Elevator Especificaciones descargar pdf (Pagina 17)

Assembly

UJK Fence Assembly

Fig 33-34

Locking nut

Step 2 Insert a grub screw into each threaded corner

of the table insert, place a straight edge across the

table insert and using a Hex key adjust the grub

screws until the table insert is level with the table top.

(See ﬁg 35)

Fig 35

Grub screw

Hex key

Straight edge

Step 3 Insert the two countersink Hex screws down

into the countersink holes in the table inset to lock

the insert in position. (See ﬁg 36)

Fig 36

Countersink Hex screw

Step 1 Locate the fence ﬁxing brackets (O) and the

eight Hex bolts (f). Line up one of the brackets with

the pre-drilled holes beneath the edge of the table

and secure in place with four Hex bolt (f), see ﬁgs 37-

38. Repeat for opposite side.

Fig 37-38

Continues Over...

Step 2 Insert three (1/4") square nuts (h) into the

machined slot to each ﬁxing bracket (O), see ﬁg 39.

Locate the two fence ﬁxing brackets (P), M6 Hex

screws (e) and at washers (j), line up the machined

slots in the bracket (P) with the square nuts (h) and

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Sin comentarios

Axminster Router Elevator Especificaciones Pagina 17