Axminster TSCE-12R Manual de instrucciones descargar pdf (Pagina 25)

Make all machine adjustments or

maintenance with the machine unplugged from

the power source. Failure to comply may cause

serious injury!

Referring to Figure 24:

．Tools: 17mm Wrench

1. Disconnect the machine from the power

source, unplug.

2. Lower the blade to its lowest point.

3. Loosen two hex cap bolts (A).

4. Take the tension off of the poly V-Belt (B)

by lifting up on the motor.

5. Remove the belt from the arbor and motor

pulleys.

6. Replace and tension the belt. Two weight

of the motor should apply enough tension

to the belt. Tighten the hex cap bolts (A).

7. Check the belt tension after the saw has

been used for a few hours. Adjust as

necessary.

Changing the Belt

Maintenance

WARNING

Cleaning

Note: The following maintenance schedule

assumes the saw is being used every day.

Daily:

Wipe down the table surface and grooves

with a rust preventive.

Clean pitch and resin from the saw blade.

Weekly:

Table surface must be kept clean and free

of rust for best results. Apply a coat of

paste wax to the surface to facilitate this.

An alternative is to apply white talcum

powder, rubbed in vigorously once a week

with a blackboard eraser; this will fill

casting pores and from a moisture barrier.

This method provides a table top that is

slick and allows rust rings to be easily

wiped from the surface. Important also is

the fact that talcum powder will not stain

wood or mar finishes as wax pickup does.

Clean motor housing with compressed air.

Wipe down the fence rails with a dry silicon

lubricant.

Periodic:

Keep the inside of the cabinet and

trunnion area clean.

Check for excessive play in the tilting and

raising mechanism and in the saw arbor

and re-adjust as required.

Check for belt tension and wear. Readjust

or replace belt a required.

Lubrication

Grease the tilting worm gear, raising

worm gear, castor system worm gear and

the trunnion areas with a good grade non-

hardening grease.

Check all adjustments after lubricating.

Miscellaneous

Routinely check condition of the following

items:

Mounting bolts

Power switch

Saw blade

Blade guard assembly

Figure 24

Always disconnect power to the machine before performing maintenance.

Failure to do this may result in serious personal injury.

- 25 -

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Comentarios a estos manuales

Sin comentarios

Axminster TSCE-12R Manual de instrucciones Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Sierras circulares Axminster TSCE-12R