Axminster TSCE-12R Manual de instrucciones descargar pdf (Pagina 19)

Mounting Front Guide Bar

1.Mounting the Front Guide Bar A

(Figure12) to the front of the saw

Table B (Figure12).

2.See the Rip Fence Alignment

instructions. This will address the

mounting of rail and Rip fence.

Rip Fence Alignment

Burning on the waste side of stock and/or the workpiece binding between the rip fence

and the back of the saw, are both indicative of the rip fence being out of square to the

blade. Check by placing a piece of 3/4”stock at the front and another piece at the rear

of the near side of the sawblade. Slide the rip fence up against these to determine

alignment. If necessary adjust the fence using the locking bolts at the back of the fence

rail. So as to prevent the fence casting catching on the fixing studs a distance of 18mm

from the fence bar to the table is required.

To reduce the potential for kickback set the rip fence so that it is slightly farther (about

1/64 in.) from the back of the blade than from the front, so that the rear teeth just miss

the stock being cut.

When adjusting the position fore and aft of the rip fence set the extrusion so that it sits

slightly above the table when clamped up against the fence casting. This will ensure

that the nylon roller underneath the casting remains in contact with the table.

Alternatively the rip fence extrusion may have been bent. Check by placing a straight

edge along its length. Either replace it, or add an auxiliary wood fence and shim it to

even out any imperfections.

Figure 12

- 19 -

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Sin comentarios

Axminster TSCE-12R Manual de instrucciones Pagina 19