Axminster AW10BSB2 Instrucciones de operaciones descargar pdf (Pagina 11)

Initial Assembly

Fig 12

Fig 13

Fig 14

Fig A

Fig B

When everything is tightened up, the machine can

now be tipped over, towards its blind face until it is

resting on the pallet with its legs on the ﬂoor. Lift

the machine upright. (See ﬁgs 13-14)

Blind face

Side extension table

Locate the rear table (6) and the other 4 No. M8

caphead bolts and washers (9). Mount the table

onto the brackets, Note: that the securing bolts

need to feed through the elongated holes in the

bracket (7), the rear extension table is spaced off

the main table to allow clearance for the rear

clamping rail and the rip fence. Leave all bolts

ﬁnger tight at this time. (See ﬁgs 15-16)

Fig 15

Fig 16

Elongated holes

Continues Over....

Side Extension Table

Locate four M8 x 16mm hexhead bolts and washers.

Ensure the table is correctly orientated. Stand the

back end of the side extension table (3A) on the

ﬂoor, close to the front and edge of the main saw

table (1), with the underside of the table facing the

front of the saw. Lift the table up and introduce a

bolt and washer through the ﬁrst hole in the table

and screw it into the ﬁrst threaded hole along the

main table edge. Repeate for the remaining bolts.

Place a level across both table surfaces and tighten

the bolts, (See ﬁgs A-B).

M8 x 16 Bolt

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Sin comentarios

Axminster AW10BSB2 Instrucciones de operaciones Pagina 11